GE GBS20KB, Дополнение к инструкции по установке

Страница: 4 / 8

4
Installation Instructions
PLUG IN THE ICEMAKER
Holding the icemaker in place, insert the icemaker
power cord plug into the socket on the rear wall,
making sure the prongs and holes are matched.
Press the plug firmly into the socket. Lock the plug
in place by clipping the restraints onto each side of
the plug. Make sure the restraints click into place.
Make sure the power cord is still in the hook on
the back of the icemaker.
6
11
MOUNT THE ICEMAKER
•
Lift the icemaker so the fill tube shipped with the
refrigerator fits in the fill cup opening (E). Hang
the icemaker on the two mounting screws (9) in
the side wall.
Make sure:
•
The power cord is still firmly in the socket.
•
The fill tube extends into the fill cup opening on
the back of the icemaker. (Check the rear of the
refrigerator to make sure the fill tube has not
been pushed out of the back of the refrigerator).
• The icemaker mounting screws are located in
the uppermost position of the mounting slots.
•
The icemaker is level.
•
The icemaker power switch is set to
O
(off).
THEN SECURELY TIGHTEN THE ICEMAKER
MOUNTING SCREWS.
7
E
9
RE-INSTALL THE SHELF SUPPORT,
BUCKET, SHELF AND BASKET
Replace the center vertical shelf support, ice bucket,
chiller shelf and storage basket by reversing the steps
in Step 1.
8
ATTACH WARRANTY LABEL
A label (7) is provided with this kit to record the
date of installation for warranty purposes. Apply it
to the back of the refrigerator.
9
KEEP THIS ADDENDUM
Keep this addendum with your Refrigerator
Owner’s Manual and Installation Instructions.
The icemaker installation inside the freezer is now
complete. Continue to the
Water Valve Assembly
section.
10
INSTALL THE ICEMAKER FILL CUP
Install the icemaker fill cup (side-mounted) (11)
into the icemaker as shown.
5
INSTALL THE MOUNTING SCREWS
• Skip to Step 5 if screws are already in place in
the freezer side wall.
•
Install two self-tapping Phillips
head screws (9) from the kit
in the holes in the side wall.
The screw heads should extend
about 1/2
″
(13 mm) from the
side wall.
4
Hook