GE Dinamap PRO Series, Руководство по эксплуатации

Страница: 19 / 20

19
Getting Started
Switching the Monitor On and Off
To switch the DINAMAP PRO Monitor on, press and hold
the power ON/OFF switch (16) for at least 10 seconds or
press the rotor (21).
As the Monitor powers up, it will run a short self-test routine,
which will flash all the indicator lights and then beep the
warning speaker. After a few seconds the system will be
ready for operation, as indicated by the appearance of the
main menu on the LCD (25).
To switch the Monitor off, push the power ON/OFF switch
(16) again. This will terminate any measurements that may be
in progress and automatically deflate the cuff.
When the Monitor is operating on the internal battery only,
battery life is enhanced by the use of the sleep mode.
However, the PRO Monitor will not enter sleep mode if an
alarm is active. If no controls are used and no determinations
are being made, the Monitor will enter sleep mode after a
time which can be preset by the operator. All LED displays
will be blanked except for a dash in the far-left systolic
position, and any existing readings will be transferred to the
LCD, which displays the message “Sleep Mode Active.”
Moving the rotor or pressing a key will “wake up” the
Monitor.
Liquid Crystal Display (LCD)
Menu Area
This area displays the name of the menu that has option
buttons available for selection. Normal text in the menu area