10
OVEN RACK GUIDE INSTALLATION
A.
Locate included oven rack guide mounting hardware.
B.
Place oven rack guides on cavity wall studs with L bracket towards back of cavity as shown.
C.
Install guides using the 8 provided mounting nuts.
31-10962 08-14 GE
Oven rack
guide shown
in place.
Metal Posts to be
installed in the
rear of cavity
French doors removed for
illustration clarity only
French doors removed for
illustration clarity only
11
DOOR ADJUSTMENT MECHANISM
Door Adjustment Mechanism is located on both the right and left doors at the bottom hinges. Only the
left side Adjustment Mechanism is shown in this manual.
NOTE:
Adjust the doors inward only until the center gap is even. Over-adjusting can damage the center
seals and make the doors more difficult to open.
A.
Using 9/16” socket wrench, tighten Vertical Adjustment Screw to adjust door up and loosen to
adjust door down.
B.
Horizontal Adjustment Screws pivot
the door about an axis. Using a 1/8”
Hex Key, loosen both screws, then
tighten appropriate screw to pivot
door. Once door is in place, verify both
screws are tightened.
EXAGGERATED EXAMPLES FOR LEFT
DOOR ADJUSTMENT
Example 1: Left door low,
center gap even.
Steps for adjustment:
A.
Tighten left Vertical
Adjustment Screw.
B.
If left door is still low, loosen
right Vertical Adjustment
Screw.
Example 2: Left door low,
center gap larger at bottom.
Steps for adjustment:
A.
Loosen inside Horizontal
Adjustment Screw.
B.
Tighten outside Horizontal
Adjustment Screw until center
gap even.
C.
If left door is still low, tighten
left Vertical Adjustment Screw.
D.
Tighten inside Horizontal
Adjustment Screw.
Example 3: Left door high,
center gap larger at top.
Steps for adjustment:
A.
Loosen outside Horizontal
Adjustment Screw.
B.
Tighten Outside Horizontal
Adjustment Screw until center
gap even.
C.
If left door is still low, tighten
Left Vertical Adjustment
Screw.
D.
Tighten Inside Horizontal
Adjustment Screw.
Vertical Adjustment Screw
Horizontal Adjustment Screws
