– 24 –
NOTE: Before installing the front panel, slowly rotate
the drum in both directions to ensure that the belt is
aligned and not twisted.
Drum Removal
1. Remove the belt from the motor pulley and idler
pulley. (See Drive Belt Removal in this guide,
and follow steps 1 through 3.)
2. Using the belt as a handle, pull the drum
forward and guide it out of the dryer cabinet.
CAUTION: To prevent damage to the dryer, the drum
must be installed with the blue threaded felt seal
toward the back of the dryer.
Drum Rollers
The stainless steel drum rotates on four drum rollers
(two on the front drum support and two on the rear
drum support).
Each drum roller comes as a complete assembly.
Drum Roller Removal
1. Remove the front bulkhead to access the front
drum rollers. Remove the drum (See Drum
Removal in this guide), to access the rear drum
rollers.
2. Each drum roller is held in place by a plastic
triangular clip. Remove the triangular clip with a
VPDOOÀDWEODGHGVFUHZGULYHUDQGVOLGHWKHGUXP
UROOHURȺWKHUROOHUVKDIW
To remove the left side drum roller shaft from the
front bulkhead:
1. Remove the front bulkhead. (See Front Bulkhead
Removal in this guide.)
2. Remove the 9/16 in. hex nut that attaches the
shaft to the front bulkhead.
To remove the right side drum roller shaft from
the front bulkhead:
1. Remove the front bulkhead. (See Front Bulkhead
Removal in this guide.)
2.
5HPRYHWKHOLQW¿OWHU
3. Disconnect the sensor wires.
NOTE
7KHVHQVRUURGVDUHSDUWRIWKHOLQW¿OWHU
KRXVLQJ7RUHSODFHWKHVHQVRUURGVWKHOLQW¿OWHU
housing must be replaced.
(Continued Next Page)
Blue Thread
