GE CDT865SxJ0 Series, Техническое обслуживание руководство

Страница: 54 / 95

– 54 –
( Continued next page )
Accessing Inverter Fault Codes
These diagnostic checks are performed with the
GLVKZDVKHUXQLQVWDOOHGDQGLQYHUWHUFRYHURȺWR
view the inverter service LED.
:LWKWKHFRYHURȺDQGDOOFRQQHFWRUVKDYHEHHQ
checked and found to be tight, reapply power to the
dishwasher. Then enter Service Mode and initiate
the proper test to run the drain or circulation pump
motors. Look at the inverter service blink pattern,
which may indicate a fault.
VHFRQGRQVHFRQGRȹ 1RUPDO5XQÀDVKSDWWHUQWKLVPHDQVDPRWRULVUXQQLQJ
VHFRQGRQVHFRQGRȹ 1RUPDO6WDQGE\ÀDVKSDWWHUQSRZHURQPRWRUQRWUXQQLQJ
ÀDVKZLWKVHFRQGSDXVH Inverter has detected house voltage below 103 VAC
ÀDVKHVZLWKVHFRQGSDXVH Inverter has detected house voltage below 132 VAC
ÀDVKHVZLWKVHFRQGSDXVH Check for a shorted Circulation motor:
Inverter connection J101 pin 4 white - pin 5 black - pin 6 red, 11 - 12
ohms.
Shorted or open, replace motor, check connectors, if OK, replace
inverter.
ÀDVKHVZLWKVHFRQGSDXVH Open TCO in Circulation Motor - check for continuity inverter connector
-SLQEURZQRUDQJHWRSLQEOXHFRQ¿UPLQJDQRSHQ7&2
Replace inverter if TCO is OK.
ÀDVKHVZLWKVHFRQG
SDXVH /5$/RFNHG5RWRU$PSVGHWHFWHGPRWRUVSHFL¿FGHWHFWHGZKHQPRWRU
is activated in service mode), check for:
1. Loose connectors.
2. Motor** (if OK, replace inverter)
3.
,QYHUWHULIERWKPRWRUVVKRZDÀDVKHUURUUHSODFHLQYHUWHU
3HUIRUPVDPHUHVLVWDQFHFKHFNVDVÀDVKHUURU
ÀDVKHVZLWKVHFRQGSDXVH Communication error.
1. Check for 5 VDC at MB J711 pins 12 - 22 (AX-CW). If 5 VDC is not
measured - replace main board.
2. Check for 5 VDC at inverter pins 1 - 3 (CW - AX). If 5 VDC is
measured, replace inverter. If 5 VDC is not measured, replace the
DC harness. If 5 VDC is measured the Inverter is powered with no
communication between MB and inverter, replace MB.
ÀDVKHVZLWKVHFRQGSDXVH Relay fault in inverter = replace inverter.
7KHVHHUURUVPD\EHWKHFLUFXODWLRQRUGUDLQPRWRU%RWKZLOOQHHGWREHFKHFNHG