GE AquaTrans AT868, Руководство пользователя, Страница: 35 / 158

September 2004
2-10 Programming Site Data
Fluid Type
1.
The selections for fluid type vary depending on whether the
Tracking Window is enabled or disabled. Press [
W
]
and [
X
] to
select the desired fluid and press
[ENTER]
. Refer to Table 2-2
below for a list of available fluids.
Table 2-2: Fluid Types
2.
If you selected
OTHER
, enter the additional information as
prompted by using the arrow keys. Press [
W
]
and [
X
] to move the
cursor to desired location and press
[
S
]
and
[
T
]
to increase or
decrease the number and press
[ENTER]
.
Reynolds Correction
1.
Press [
W
]
and [
X
] to select whether to activate or deactivate the
Reynolds Correction Factor and press
[ENTER]
.
Note:
Typically, Reynolds Correction is set to active.
2.
Do one of the following:
•
If you selected
OFF
, enter the Calibration Factor and press
[ENTER]
. Then, proceed to one of the following sections:
•
For Clamp-on Transducers - proceed to Number of
Traverses and Transducer Spacing on page 2-12.
•
For Wetted Transducers - The meter returns to the
Channel
PROGRAM
window. At this point, you can continue
programming in this submenu as desired. To leave the
Channel PROGRAM
window, press
[ESC]
three times. To
complete setting up the meter, you must enter data in the
GLOBL-SYSTM
submenu as described on page 2-22.
•
If you selected
ACTIV
, proceed to KV Input Selection on
page 2-11.
Tracking Windows =
NO YES
WATER W100 (Water, 0°-100°C)
OTHER W260 (Water, 0°-260°C)
Oil, Tracking
OTHER