GE AquaTrans AT868, Руководство пользователя, Страница: 36 / 158

Programming Site Data 2-11
September 2004
KV Input Selection
1.
Press [
W
]
and [
X
] to enter a static kinematic viscosity or a table
of values and press
[ENTER]
.
2.
Do one of the following:
•
If you selected
Table
, enter the Calibration Factor by using the
arrow keys. Press [
W
]
and [
X
] to move the cursor to desired
location and press
[
S
]
and
[
T
]
to increase or decrease the
number and press
[ENTER]
.
Note:
The values in the KV/SS table can be edited as described in
Entering KV/SS Table on page 2-18.
•
If you selected
STATC
, the AT868 will select and automatically
display the Kinematic Viscosity (see note below). If you want
to enter a different number use the [
W
]
and [
X
] to move the
cursor to desired location and press
[
S
]
and
[
T
]
to increase
or decrease the number and press
[ENTER]
. Then enter the
Calibration Factor in a similar manner and press
[ENTER]
.
Note:
If you select
OTHER
as the fluid type, you must enter the
Kinematic Viscosity. The AT868 will only approximate the
Kinematic Viscosity if you select one of the available fluid
options other than
OTHER
(i.e. water, oil, etc.).
3.
Proceed to one of the following sections:
•
For Clamp-on Transducers - proceed to Number of Traverses
and Transducer Spacing on page 2-12.
•
For Wetted Transducers - The meter returns to the
Channel
PROGRAM
window. At this point, you can continue
programming in this submenu as desired. To leave the
Channel
PROGRAM
window, press
[ESC]
three times. To complete
setting up the meter, you must enter data in the
GLOBL-SYSTM
submenu as described on page 2-22.