GE APE07, Руководство пользователя

Страница: 5 / 32

■
To ensure proper operation, aim the
remote control at the signal receiver on
the air conditioner.
■
The remote control signal has a range of up to
21 feet.
■
Make sure nothing is between the air conditioner
and the remote control that could block the
signal.
■
Make sure batteries are fresh and installed
correctly—see the
Using the portable air conditioner
section.
Remote Control
www.GEAppliances.com
When the air conditioner is turned on, it will
automatically start in the default setting.
COOL Mode
Use the COOL mode with HIGH, MID or LOW fan
for cooling. Use the
TEMPERATURE INCREASE
▲
/
DECREASE
▼
pads to set the desired temperature
between 61°F and 86°F in 1°F increments.
A thermostat is used to maintain the room
temperature. The compressor will cycle on and off
to keep the room at the set level of comfort. Set the
thermostat at a lower number and the indoor air
will become cooler. Set the thermostat at a higher
number and the indoor air will become warmer.
NOTE: If the air conditioner is off and is then turned on
while set to COOL , it will take approximately 3 minutes
for the compressor to start and cooling to begin.
Cooling Descriptions
For Normal Cooling—
Select the
COOL
mode and
HIGH
or
MID
fan with a middle set temperature.
For Maximum Cooling— Select the COOL mode
and HIGH fan with a lower set temperature.
For Quieter & Nighttime Cooling—
Select the
COOL
mode and
LOW
fan with a middle
set temperature.
NOTE: If you switch from a COOL setting to OFF or to
a fan setting, wait at least 3 minutes before switching
back to a
COOL setting.
FAN Mode
Use the
FAN
at
HIGH, MID
or
LOW
to provide air
circulation and filtering without cooling. Since fan
only settings do not provide cooling, a temperature
setting will not be displayed.
DRY Mode
Use the
DRY
mode to provide dehumidification
only. The fan will run at a low fixed speed at this
setting. Keep windows and doors closed for the best
dehumidifying effects. When using the
DRY
mode,
detach the exhaust hose from the unit and remove
the window slider or seal the opening in the
window exhaust adapter.
NOTES:
If you switch from a
DRY
setting to
OFF
or to a fan
setting, wait at least 3 minutes before switching back
to a
DRY
setting.
The compressor runs in this mode.
Consumer Support
Tr
oubleshooting T
ips
Operating Instructions
Safety Instructions
Care and Cleaning
5
AUTO Mode
Set to
AUTO
for the temperature and fan speed to
automatically provide optimum comfort settings.
NOTE: DRY will also appear in the display when using
the AUTO mode.