normal
1. Set Selector Switch at HIGH
COOL.
2. Set Thermostat Control at
desired number
the midpoint
is a good starting position). If room
temperature is not satisfactory after
a reasonable time, set the Thermostat
Control at a higher number for a
cooler room or at a lower number
for a warmer room.
For maximum
1. Set Selector Switch at HIGH
COOL.
2. Set Thermostat Control at 10.
3. Set Ventilation Control at
CLOSE position.
For quieter operation
1. Set Selector Switch at LOW
COOL.
Set Thermostat Control at
desired number.
3. Set Ventilation Control at
CLOSE position.
For
operation
During the cooler evening hours,
it is recommended that you set the
Selector Switch at LOW COOL
for very quiet operation and the
Thermostat Control at mid range
(5 or 6).
When the Thermostat Control is set
on 9 or 10 and the Fan is operating
at low speed, moisture may freeze
on the coils and prevent the unit
from cooling If this happens, set
the Fan at high speed and set the
Thermostat Control to a lower
number.
For extreme temperatures
For greatest economy and best
performance, we suggest you
always set the Selector Switch at
HIGH COOL in extremely hot
weather.
For air circulation and
without
or
Turn Selector Switch to fan setting.
For ventilation
Whether controls are
set for cooling, heating
(on heat/cool models)
or fan only operation,
setting the Ventilation
Control at OPEN lets
room air be exhausted
to the outside. This is
helpful in removing
stale air, smoke or
odors from the room,
and permits outdoor
air to enter through
normal openings in
the house. However,
cooling effectiveness
is reduced when this
control is set at OPEN,
so we suggest you don’t
CLOSE
●
●
●
OPEN
Control
keep it
there long—especially in hot,
humid weather.
For normal
(Heat/Cool models only)
1. Set Selector Switch at HEAT.
2. Set Thermostat Control at
number
the midpoint
is a good starting position). If room
temperature is not satisfactory after
a reasonable time, set the Thermostat
Control at a lower number for a
warmer room or at a higher number
for a cooler room.
For maximum
(Heat/Cool models only)
1. Set Selector Switch at HEAT.
2. Set Thermostat Control at 1.
3. Set Ventilation Control at
CLOSE position.
To adjust air direction
Up and down
Tabs let you direct discharged air
up, down or straight ahead.
Side to side
ON
●
●
OFF
Circulaire Switch
For
continuous side-to-side air
circulation, set the Circulaire Switch
to ON and leave it there. Vertical
air deflector blades direct air
throughout the room.
For fixed side-to-side air direction,
set the Circulaire Switch to ON until
the desired air direction is obtained,
then move it to OFF.
5