GE AMX 4+, Техническое руководство

Страница: 36 / 132

3-2
4. Carefully remove the detent assembly consistingof two springcovers, two springs
and one shaft with one bearingfrom recessed location in yoke mountingplate.
5. Slide three springwashers, disk, thrust washer and yoke mountingplate from the
shaft on horizontal arm.
6. Remove thrust bearingand thrust washer from horizontal arm shaft.
) %! &&#"(
$&'""' %$
1. Lubricate thrust bearingwith small amount of lithium (Fiske 630-A-A or
equal) grease.
2. Install thrust washer and thrust bearingon horizontal arm shaft. See Illustration
3-1.
3. Place yoke mountingplate with tube supports on horizontal arm shaft.
4. Slide thrust washer, disk, and three springwashers onto horizontal arm. (ConĆ
cave side of springwasher facingyou)
5. Place two springs and spring covers into recessed position in face of mounting
plate.
6. Place shaft with bearingon the two springs and carefully install cover over end
of horizontal arm shaft.
7. Hold cover in place on horizontal arm shaft to prevent detent assembly from
springing loose and secure with four capscrews.
8. Install the x-ray tube. Refer to Section 2.
9. Install the collimator. Refer to Section 1.