Consumer Support
Tr
oubleshooting T
ips
Operating Instructions
Safety Instructions
Installation Instructions
15
Problem
Possible Causes
What To Do
Air conditioner
The air conditioner
•
Make sure the air conditioner plug is pushed completely
does not start
is unplugged.
into the outlet.
The fuse is blown/circuit
•
Check the house fuse/circuit breaker box and replace
breaker is tripped.
the fuse or reset the breaker.
Power failure.
•
The unit will automatically re-start in the settings last
used after the power is restored.
•
There is a protective time delay (approximately
3 minutes) to prevent tripping of the compressor
overload. For this reason, the unit may not start
normal cooling for 3 minutes after it is turned
back on.
The current interrupter
•
Press the
RESET
button located on the power cord plug.
device is tripped.
•
If the
RESET
button will not stay engaged, discontinue
use of the air conditioner and contact a qualified service
technician.
Air conditioner does not
Airflow is restricted.
•
Make sure there are no curtains, blinds or furniture
cool as it should
blocking the front of the air conditioner.
The temp control may
•
On models with touch pads: In
COOL
mode, press the
not be set correctly.
DECREASE
▼
pad.
•
On models with control knobs, turn the temperature
knob to a higher number.
The air filter is dirty.
•
Clean the filter at least every 30 days.
See the
Operating Instructions
section.
The room may have been hot.
•
When the air conditioner is first turned on you need to
allow time for the room to cool down.
Cold air is escaping.
•
Check for open furnace floor registers and cold air
returns.
•
Set the air conditioner’s vent to the closed position.
Cooling coils have iced up.
•
See “
Air conditioner freezing up
” below.
Air conditioner
Ice blocks the air flow
•
On models with control knobs, set the mode control at
freezing up
and stops the air conditioner
HIGH FAN
or
HIGH COOL
with the temp at
1
or
2
.
from cooling the room.
•
On models with touch pads, set the controls at
HIGH (F3) FAN
or
HIGH (F3) COOL
and set the thermostat
to a higher temperature.
The remote control
The batteries are inserted
•
Check the position of the batteries. They should be
is not working
incorrectly.
inserted in the opposite (+) and (–) direction.
The batteries may be dead.
•
Replace the batteries.
Water drips outside
Excessively hot and
•
This is normal.
humid weather.
Water drips indoors
The air conditioner is not
•
For proper water disposal, make sure the air conditioner
tilted to the outside.
slants slightly from the case front to the rear.
Water collects in
Moisture is removed from
•
This is normal for a short period in areas with little
base pan
indoor air and drains into
humidity; normal for a longer period in very humid
rear of a cabinet where a fan
areas.
blows it against the outdoor
condenser coil.
TIMER feature not
A power outage or interruption
•
In the case of a power outage or interruption, the unit
working properly
occurred.
TIMER
feature will reset to the original setting. You may
need to set a new time if desired.
Troubleshooting Tips.
ge.com
Troubleshooting Tips
Save time and money! Review the chart below first
and you may not need to call for service.
