GE ABB ReliaGear SB, Инструкция по установке, эксплуатации и обслуживанию

Страница: 7 / 32

I N S TA L L AT I O N , O P ER AT I O N S A N D M A I N T EN A N C E M A N UA L 7
—
04
—
04
Lifting the switch-
board with a forklift
If it is necessary to store the equipment for any
length of time, observe the following precautions
to prevent corrosion or breakage:
• Keep the switchboard in an upright position and
store on a flat, stable surface
• Store the switchboard in a clean, dry, rodent-free
area in moderate temperature. Cover the
equipment to prevent deposits of dirt or other
foreign material on movable parts and electrical
contact surfaces (heavy-duty plastic is
recommended for covers). Until they are properly
installed, outdoor switchboards are not
weatherproofed
• If the switchboard is stored in cool or damp
areas, apply heat to keep it dry. On both indoor
and outdoor switchboards, two standard 100 W,
120 VAC lamps can be installed in each section to
keep the switchboard internally dry
DANGER
WARNING
CAUTION
NOTICE
SAFETY
INSTRUCTIONS
Caution:
Remove all cartons and other
miscellaneous packing materials from inside the
units before energizing any heaters or lamps.
Forklift
Only trained personnel should operate the forklift.
Make sure the switchboard is on a solid surface
and be aware of wet floors and other hazardous
conditions. The switchboard load should be
properly distributed to avoid damage to the
equipment. Follow any operational procedures and
do not exceed the lifting capacity of the forklift.
Before lifting, ensure that the forks/blades of the
forklift are fully inserted under the switchboard
and that they extend under the entire skid (Figure
4). The switchboard may be top heavy and should
be secured to the forklift with a safety strap. The
strap must be located properly to stabilize the
equipment and should not be placed over any
components that may be damaged by the strap.
Lift the switchboard slowly to the minimum height
necessary to move the equipment safely.
Storage
Use belt
to fork lift
Fork lift
from under
skid only
UP
* Use a strap to secure the switchboard to the forklift.