39
Installation Instructions
The Pr
oblem Solver
QUESTIONS?
USE THIS PROBLEM SOLVER
PROBLEM
POSSIBLE CAUSE
SURFACE UNITS WILL
• You must use pans which are absolutely flat. If light can be seen between
NOT MAINTAIN A ROLLING
the pan bottom and a straight edge, the elements will not transfer heat properly.
BOIL OR FRYING RATE IS
• Pan bottoms should closely match the diameter of the surface unit selected.
NOT FAST ENOUGH
FOODS COOK SLOWLY
• Improper cookware being used. Pan bottoms should be flat, fairly heavy-weight
and the same diameter as the surface unit selected.
SURFACE UNITS DO NOT
• Difficulty may be in the main distribution panel of your house, caused by a
WORK PROPERLY
blown oven-circuit fuse, a tripped oven-circuit breaker, the main fuse or the
main circuit breaker, depending on the nature of the power supply. If a circuit
breaker is involved, reset it. If the control box uses fuses, the oven fuse
(a cartridge-type) should be changed, BUT ONLY BY SOMEONE FAMILIAR
WITH ELECTRICAL CIRCUITS. If after performing one of these procedures,
the fuse blows or circuit breaker trips again, call for service.
NOTE: Apartment tenants or condominium owners should ask their building
management to perform this check before calling for service.
• Cooktop surface unit controls are not properly set, or the wrong control knob
is set for the surface unit you are using.
TINY SCRATCHES
• Incorrect cleaning methods have been used, cookware with rough bottoms has
(may appear as cracks) OR
been used, or coarse particles (salt or sand) were between the cookware and the
ABRASIONS ON RADIANT
surface of cooktop. Use recommended cleaning procedures, be sure cookware
COOKTOP GLASS SURFACE
bottoms and cookware are clean before use and use cookware with smooth
bottoms. Tiny scratches are not removable but will become less visible in time
as a result of cleaning.
METAL MARKINGS
• Do not slide aluminum cookware across the surface. Use recommended
(may appear as scratches)
cleaning procedure to remove marks.
• Incorrect cleaning materials have been used, encrusted boilovers or grease spatters
remain on the surface. Use a razor scraper and recommended cleaning procedure.
DARK STREAKS
• Use a razor scraper and recommended cleaning procedure.
OR SPECKS
AREAS OF
• Marks from aluminum and copper pans as well as mineral deposits from water
DISCOLORATION
or food can be removed with the cleaning cream.
ON COOKTOP
HOT SUGAR MIXTURES/
• See the Glass Cooktop Cleaning section.
PLASTIC MELTED TO
THE SURFACE
FREQUENT CYCLING
• Incorrect cookware used. Use only flat cookware to minimize cycling.
OFF AND ON OF
SURFACE UNITS
(continued next page)