8
Programming Your Remote, cont.
Auto Code Search
The Auto Code Search searches automatically
through the codes stored in this remote. Read all the
following steps prior to starting the auto code search
as you will need to be prepared to lock-in the proper
code when found.
1. Manually turn on the device you wish
to control.
2. Press and hold the
SETUP button
until the red indicator light stays on
(approximately 2 seconds) and then
release the button.
3. Press and release the desired device
button on the remote (
TV, DVD, CBL,
SAT, DVR, AUX, AUDIO, VCR) the type
of device you wish to control. The
red indicator will blink once and then
remain on.
4. Point the remote at the device and
press and release the
POWER button
(for TV) or
PLAY button (for DVD, VCR,
etc.) to start the search. The red
indicator will flash (approximately
every 2 seconds) as the remote
searches.
Note: The remote must be
pointed at the device for the duration of
this search.
5. Place your finger on the
#1 button so
you are prepared to lock-in the code.
6. When the device shuts off or begins
playing, press the
#1 button to lock-in
the code. The red indicator light will
turn off.
Note: You have approximately
two seconds after the device shuts off
or begins playing to lock-in the code.
7. Point the remote at the device and
check to see if the remote operates the
device as desired. If it does, no further
programming is required for that
device. If it does not, return to step 2
and start the auto code search again.
tv
setup
