17
Remote Control
If you want to control multiple fans using separate remotes and do not have separate
circuit breakers for each fan, contact customer service at
1-866-885-4649
.
Step 1. Shut off power to all fans at wall switch. At the circuit breaker,
reset the power (turn OFF and back ON) for the fan you are
re-programming.
Step 3
.
Repeat steps for each fan that needs re-programming.
Step 2.
Within 30 seconds
of resetting the power, turn wall switch back
on, switch the lock /unlock button on the back of the transmitter to
“
lock
” position. Push the Sync “ ” button for about 5-10 seconds,
until the light on the fan flashes 3 times.
In Case Of Interference With Other Fans, You Can Change The
Transmitter Code To Operate This Fan Only.
Unlock Position
Lock Position
Operate Fan Using Transmitter Code Pre-set by Factory
( Keep Switch Placed In Unlock Position )
Step 1. Restore power to ceiling fan.
Step 2. Install two 1.5-volt AAA batteries provided.
Step 3. Press the “ ” button located on the front
of the transmitter to operate the fan.
Step 4. Press the “ ” button to operate the light .
A dimmer feature is provided on the light .
Press all the way down to get maximum light .
Note:
The
blue light will illuminate to indicate the transmitter
is working.
FCC ID: 2AAZPFAN61T3SP1
