GE 17k, Руководство оператора

Страница: 33 / 128

33
you must have the following information at hand if it is
necessary to contact a local service center regarding
service or repair of this unit:
1. Obtain the unit Model Number and Serial Number
from the unit ID label. See
Controls
for location of
the label or refer to the information recorded on the
inside front cover of the installation manual.
2. Obtain the engine identification numbers from the
engine label. See Controls for location of the label or
refer to the information recorded on the inside front
cover of the installation manual.
When calling for assistance
The home generator system is designed for long term service
as a backup generator. There is no need to take any storage
precautions. However, if it becomes necessary to take the
system out of service for an extended period, call Technical
Services at
888 575-8226 , between 8:00 AM and 5:00 PM CT
for specific recommendations.
Storage
clean air cooling System and oil cooler Fins
Over time debris may accumulate in cylinder cooling fins
and cannot be observed without partial engine disassembly.
Unobstructed air flow is critical for correct generator
operation. For this reason, we recommend you have an
authorized service dealer clean the cooling system per
recommended intervals (see
Maintenance Schedule
in the
Maintenance
section). Equally important is to keep top of
engine free from debris. Make sure the oil cooler fins are free
of dirt and debris. Also see
Cleaning
.
Service Spark Plugs
Changing the spark plugs will help your engine to start easier
and run better.
1. Clean area around spark plugs.
2. Remove and inspect spark plugs.
3. Check electrode gap with wire feeler gauge and reset
spark plug gap to recommended gap if necessary
(see
Specifications ).
4. Replace spark plugs if electrodes are pitted, burned
or porcelain is cracked. Use the recommended
replacement spark plugs. See
Specifications
.
5. Install spark plugs and tighten to 180 in/lbs (20Nm).