GE Security Simon XT, Руководство пользователя

Страница: 21 / 60

Chapter 2
Using the control panel
15
Using an offsite phone
If enabled by the installer, you can control your Simon XT panel remotely from an offsite phone. The panel
answers a phone call according to the dialing method programmed by your installer.
After a certain combination of rings and pauses, the panel will answer the call with the voice prompt Enter
your code . You must enter the correct code to gain access.
If you are interacting with your panel and the panel hangs up on you, the system is calling in a report to the
central monitoring station or remote phone due to an action by you or someone at the security system site. The
actions listed in
Table 6 may be performed from an offsite phone.
Table 6. Phone controls
Action Phone keypresses Comments
Disarm
1
System not already disarmed
Subdisarm
1
Must have used the master code to gain access; system
was disarmed
Arm doors and windows (Stay)
2
Press 2 again to activate No delay feature
Arm doors, windows, and
motion sensors (Away)
3
Press 3 again to activate Latchkey feature
Check status
0
Turn light on * – <unit_num>. N = 1-8, unit number
Turn light off # – <unit_num>. N = 1-8, unit number
Turn all lights on
* – *
Turn all lights off
# – #
Hang up
9
2-way voice session
5
During session, pressing 1 turns speaker on, 3 turns
microphone on, 9 ends session (hangs up). If no keypresses
are heard by the panel for 90 seconds, it will hang up. After
each keypress, the panel will send a short tone.