GE Security Legend IP, Руководство по установке

Страница: 57 / 82

Chapter 5
Using passcodes
49
6. Since passcodes are turned off by default, upon initial installation you can directly access the
programming interface without a passcode ( Figure 26 ).
Note: For complete instructions for navigating the programming interface and programming with it, refer to the
Legend IP
User Manual (1055713).
Figure 26. First screen of programming interface when passcodes are turned off
3. At the equipment selection display, press 3 to
select CAMERA (keypad v1.2.09 or later) or
CAMERA/RCVR (keypad v1.1.06 or
earlier).
If you have an older keypad (v1.1.06 or
earlier), you will have a second equipment
selection display, at which you need to press
1 for CYBERDOME.
Figure 23. Equipment selection display
4. At the ENTER CAMERA SITE NUMBER
display, enter the number for the camera site
you are programming. This is a 3-digit
number (for example, 007, 021, 243).
You can enter one, two, or three digits and
press
set ( ).
Figure 24. ENTER CAMERA SITE NUMBER display
5. Continue entering commands with the
joystick.
Figure 25. SEE MONITOR FOR MENUS display
1=SWITCHER/MPLX 2=ALARMS
3=CAMERA EXIT
1=SWITCHER/MPLX 2=ALARMS
3=CAMERA/RCVR EXIT
1=CYBERDOME 2=PTZ
3=AUXILIARY
BACK
v1.2.09
or later
v1.1.06
or
earlier
}
ENTER CAMERA SITE
NUMBER _ _ _
BACK
SEE MONITOR FOR MENUS
HOLD SEQ (3 SEC) TO EXIT