GE Security Legend IP, Руководство по установке

Страница: 36 / 82

Legend IP
Installation Manual
28
Figure 10. Installing the pendant-mount housing
Typical pipe-mount
Wall
Typical wall-mount
Wall mount
Safety
chain
Use the safety chain
and screws provided.
Cables fed through
mount and housing.
Ceiling
Water-sealing rubber boot
(for outdoor applications)
Teflon tape
Housing lifted
and threaded
(turned clockwise)
onto pipe.
If necessary,
housing turned
counterclockwise
to compensate
for cable twist.
Cables fed through
pipe and housing.
Cables are fed as follows:
• all cables run down through
the cable entry hole and the
dust seal;
• the power cable runs over the
top of the upper bracket and
down beside the power
connector; and
• the remaining cables run
down through the center hole
in the upper bracket.
Pendant-mount cabling
Upper bracket
Cable entry hole
Dust seal
Power cable
See Table 1, Minimum load re-
quirements of dome configu-
rations on page 9.
Ceiling
Water-sealing rubber boot
(for outdoor applications)
Teflon tape applied to
pipe threads after the
boot is slid up.
Soapy water
sprayed on
pipe before
the boot is
slid up.