GE HEALTHCARE CARESCAPE Monitor B650, Техническое руководство

Страница: 99 / 240

Configuration
91
2062973-002
−
The Save As window will show you the name of the created settings file.
− Select Save to save the settings file to the USB flash drive.
NOTE: You may change the default filename, but do not change the file extension.
NOTE: Do not disconnect the USB storage device until saving is complete.
NOTE: As a factory default the ICU software package is always activated.
7.16.2 Loading settings
Load the saved platform and/or clinical settings from a service PC or USB flash drive to the
patient monitor.
NOTE: The loaded settings will remain in an inactive state in the patient monitor until they are
purposely activated by the user (see section”
7.16.3 Activating settings ”).
1. Log in to Webmin.
2. Select Configuration > Settings .
3. In the Sub-Modules for Settings menu, select Load .
4. According to your Webmin access:
a. If you are using Webmin on a service PC, you can load the settings file from any mass
storage device connected to the service PC:
− In the Load Settings window, enter the file name or select Browse to select a file
from the Choose File to Upload dialog box.
−
Select Upload to load the settings.
b. If you are using Webmin locally through the integrated browser, you can load the settings
file from a USB flash drive that is connected to one of the patient monitor’s USB ports:
−
The Load Settings window will show you the available settings files. Select the
settings file to be loaded.
− Select Load Settings to load the selected settings file from the USB flash drive.
NOTE: Do not disconnect the USB storage device until loading is complete.
7.16.3 Activating settings
NOTE: Settings activation takes place only when the patient monitor is in a case reset / patient
discharged state. If you are going to activate settings immediately, verify that the patient
monitor is in a case reset / patient discharged state. You can alternatively initiate the setting
activation process with a delay during an active patient case, but the new settings will activate
only after the next case reset / patient discharged.
1.
Log in to Webmin.
2. Select Configuration > Settings .
3. In the Sub-Modules for Settings menu, select Activate .
4. In the Activate Settings window, select the settings that you want to activate: