19
4.15
FACTORY RESET
Please note a Factory reset would require the service provider to re-activate the pager.
Should you need to perform a Factory Reset, move the highlight to
Reset
, then press the
Select
button. Then move the highlight to
Factory reset
and press the
Select
button.
4.16
DELETE FIRMWARE
Deleting the firmware would require the firmware to be re-loaded by GDB. Do not perform
this action unless you have been instructed to do so by either your service provider or GDB.
Should you need to perform a firmware deletion, move the highlight to
Reset
, then press the
Select
button. Then move the highlight to
Delete firmware
and press the
Select
button.
4.17
WIPE DEVICE
Wiping the device would require it to be returned to the factory for re-programming using a
hardware programmer. Do not perform this action unless you have been instructed to do so by
either your service provider or GDB.
Should you need to perform a device wipe, move the highlight to
Reset
, then press the
Select
button. Then move the highlight to
Wipe device
and press the
Select
button.
4.18
POWER SETTINGS
To change your
pager’s power settings, move the highlight to the power icon
using the
Left
or
Right
navigation buttons and press the
Select
button. The screen turns off
automatically after 20 seconds without activity. This is to preserve battery life and to prevent
accidental button presses. To unlock the screen, briefly press the
Select
button again.
Figure 4.18-1