DU-DR-0015-ME0046 Rev A 2/3/00 GCX Corp.
Page 2 of 2
INSTRUCTIONS FOR USE
Pivot
1. To pivot or move, simply push on the side of the Arm
or the monitor.
2. To adjust the tension of the pivot action, tighten or
loosen the pivot adjustment screw (at the top of pivot
block, above the slot, just below the arm) with the hex
key provided.
Swivel
1. To rotate, simply push or pull the corners of the monitor.
Tilt
1. Rotate Tilt Knob clockwise or counterclockwise to adjust
tilt
angle.
Cleaning
1. The mounting assembly may be cleaned with most mild, non-abrasive solutions commonly used in the hospital
environment (e.g. diluted bleach, ammonia, or alcohol solutions).
2. The surface finish will be permanently damaged by strong chemicals and solvents such as acetone and
trichloroethylene.
3. Steel wool or other abrasive material should never be used.
4. Damage caused by the use of unapproved substances or processes will not be warranted. To verify compatibility,
It is recommended that any cleaning solution be tested on a small area of the arm that is not visible.
5. Never submerge the mounting arm. Wipe any cleaning agents off of the arm immediately, using a water-dampened
cloth. Dry the arm thoroughly after cleaning.
CAUTION
: GCX makes no claims regarding the efficacy of the listed chemicals or processes as a means for
controlling infection. Consult your hospital’s infection control officer or epidemiologist. To clean or sterilize
mounted devices or accessory equipment, refer to the specific instructions delivered with those products.
PARTS LIST
GCX P/N
Dräger P/N
GE-MMS P/N
DESCRIPTION
DR-0015-20
MM15689
12” Pivot Arm & Julian Fittings
Mounting Plate
Pivot Block
Pivot Tension
Adjustment
Screw
Locating Plunger
Tilt Knob
