Operation
Notice: If you are installing the entire Z-Wave™ system for the first time, please
refer to the installation guide of Z-Wave™ Interface Controller and full charging the
arrival sensor before using..
LED Status:
- Charging: Red LED on.
- Charge Completely: Green LED on.
- Not Included: Red LED flashing.
1. For “
Inclusion
” in (adding to) a network: Put the Z-Wave™ Interface Controller into
“inclusion” mode, and following its instruction to add the arrival sensor to your
controller. To get in the “inclusion” mode, press the Program Switch of arrival sensor
then the device will send a signal to be included (or excluded) to/from the network;
otherwise, arrival sensor will go to sleep after 30 seconds.
For
“Exclusion”
from (removing from) a network: Put the Z-Wave™ Interface
Controller into “exclusion” mode, and following its instruction to delete the arrival
sensor from your controller. Press the Program Switch of arrival sensor to be
excluded.
Note:
All user and network settings will be cleared and the device reset to factory
defaults when the device is excluded.
2.
Trigger Response:
- The sensor will send Notification Report (refer to Table 1 & 2) if it has been moved.
- The sensor will send Notification Report (refer to Table 1 & 2) and exceed
the preset detecting time (refer to Table 3).
3.
Wake Up Notification
:
Press the program switch, arrival sensor will be “Wake Up Mode” for receiving all the
command class from controller. The arrival sensor will go to sleep mode or it will wait
10 seconds then go sleep mode. It will proceed all the commands after sending the
“Wake Up Notification”
4.
Auto Wake Up:
Use “Wake Up” command to set up the awaking time and send the wake up
notification to controller. User can use command to change the auto wake up from
10 minutes to 1 week, Interval increment is 3 minutes.
(Default Value: 30 minutes.)
5.
Battery Capacity Detection
:
Use “Battery Get” command to have the battery capacity back in %. It will detect the
battery capacity automatically. Low Battery Auto Report (low battery is set as 3.2+/-0.1
Voltage).
6.
Association
:
* Support one group with 1 node.
* Group 1 = Lifeline
7. Support Explorer Frame Function
8. All the rest commands depend on Z-Wave standard
9.
Factory Default Reset:
Long press the program switch up to 10 seconds to send the
“Device Reset Locally Notification” command and reset to the factory default.
(Remark: This is to be used only in the case of primary controller being inoperable or
otherwise unavailable.)
10. Support OTA Firmware update from controller. Please refer to your controller manual.
Once OTA function success, we recommend you exclusive the device & inclusive
again before use the device.
11. Support SECURITY S0, SECURITY S2 UNAUTHENTICATED & SECURITY S2
AUTHENTICATED.
12. Support SmartStart, please scan the QR Code from ARRIVAL SENSOR for SmartStart.
QR code and PIN is located on the device, also there is a Full DSK string on the
enclosed DSK card. Please keep DSK card carefully for future inclusion needed.
(P.S.: Z-Wave SmartStart aims to shift the tasks related to inclusion of an end device
into a Z-Wave network away from the end device itself, and towards the more
user-friendly interface of the gateway.)
13. A Security Enabled Z-Wave Controller must be used to fully utilize the products.
-3-
-4-