GCE FIT+, Инструкция по эксплуатации

Страница: 5 / 120

5/120
EN
1.
Two/three cone nozzles or fl at seat nozzles with sleeve nut (BGR,
X541, FIT, Jetstream, BM31 and similar)
• Place the cutting nozzle into the heating nozzle and put the heating nozzle
to the torch head.
• Put the nut over the nozzle and fi x it in the thread manually.
• Tighten the nut with proper wrench using torque 22NM.
• Always use and counter-wrench as shown on the picture to avoid twisting
of the internal tubes which could cause gas leakage or equipment damage.
1.
Cutting and heating nozzles with thread (BIR+ and similar)
• Tighten the cutting nozzle into the heating nozzle with proper wrench by
torque 5NM.
• Tighten the heating nozzle by proper wrench using torque 15NM.
• Always use and counter-wrench as shown on the picture to avoid twisting
of the internal tubes which could cause gas leakage or equipment damage.
2.
2.
3.