8/96
EN
•
Unscrew the connecting nut (10) and remove the tightening plug.
•
Mount the quick connection valve (6) after checking that the O-ring is correctly
positioned. Tighten by means of the special tool 325 197 290 and check dur-
ing the tightening that the guide slot is positioned upwards, corresponding to
12 on a clock face. (See sketch.)
•
Place the correct name plate (5) on the transparent cover plate (4) (the screw
holes shall be in horizontal position) and mount it with the two screws (3). (Do
not use too much force!)
•
Fasten the push plate (2) with circlip (1).
•
Test the function of the coupling by connecting a dosage device with a male
coupling. The coupling should only release its grip when the push plate (2) is
pressed inwards.
6.2.3. EXPOSED GAS OUTLET MC 70
8 10
6
10
11
4
5
2 1
12
7
3
Side view
Guide slot
FIRST CHECK THAT THE VALVE BODY IS FOR THE CORRECT TYPE OF
GAS!
The valve is plugged and leakage-tested upon delivery.
•
Mark out where to place the outlet valve.
•
Place the valve body (8) in position on the wall and fasten it with the two
enclosed plaster screws (12).
•
Solder the copper pipe to the correct gas pipe (use cadmium-free silver sol-
der.)
•
Make a pressure test of the pipe connection. Use the protecting cover until
the valve is mounted, so that dust will not contaminate the valve body.
•
Unscrew the connecting nut (10) and remove the tightening plug.
•
Mount the quick connection valve (6) after checking that the O-ring is correctly
positioned. Tighten by means of the special tool 325 197 290 and check dur-
ing the tightening that the guide slot is positioned upwards, corresponding to
12 on a clock face. (See sketch.)
•
Place the correct name plate (5) on the transparent cover plate (4) (the screw
holes shall be in horizontal position) and mount it placed in the wall box (11)
with the two screws (3). (Do not use too much force!)
