GCC Technologies StellarMark 3DS, Руководство пользователя

Страница: 76 / 87

StellarMark 3DS User Manual
Rev.2.0
72
`
⚫
The Input and Output pins on the Control Unit are corresponding with
the I and O signals on the MM3D marking software property table as
below:
(1)
Input pins
Ready
(Out)
OUTPUT
➢
When MM3D software is opened, it will send out a
signal out.
➢
When the “Marking” window jumps out and laser
Marker is ready to fire; it will send a signal out.
➢
When laser marker is firing, it will send a signal out.
I1~I8 INPUT There are 8 input signals (External device → Stellar
Mark) available to communicate with external devices
STOP INPUT When Stop- pin and Ground pin are at short status, laser
marker will stop working.
START INPUT When Start- pin and Ground pin are at short status, laser
marker will trigger the fire.
E-Stop INPUT
This is terminal used to connect external
emergency stop.
GND POWER Ground
24V POWER
(Output)
A 24V is available
Not Available
The pin 9 to pin 16
input status are not
available to
communicate with laser
marker.