GCC Technologies LaserPro X252RX, Руководство пользователя, Страница: 24 / 115

23
232001240G(08)
NOTE
Support will not be offered, if you experience output problems with non-supported
graphics software.
4.2.1 Recommended Computer Configuration
The LaserPro X252RX & X380RX operates under Windows operating systems and is
designed to work on a computer that meets the following minimum requirements.
Computer
•
CPU Pentium 90 (or equivalent) or greater
•
RAM 32MB or higher
•
HDD 1.2 GB Hard Drive or greater
•
SVGA 15” Super VGA Monitor
•
On Board Parallel Mode (Enabled from your motherboard’s BIOS):
•
SPP – Preferred Mode
•
ECP – Cable (Less than 1.8 meters)
Software
•
The LaserPro X252RX & X380RX drivers are designed for Windows 7, or newer
operating systems.
4.2.2 Installation of the LaserPro Print Driver
1) Insert the LaserPro CD.
2) From the auto run menu, select X252RX & X380RX
LaserPro Driver to start
the LaserPro Print Driver installation.
3) At the Local or Network Printer page, select <Local printer attached to this
computer>, then click Next to continue.
4) At the Select a Printer Port page, select <Use the following port> and select the
port that the LaserPro X252RX & X380RX will be attached to, then click Next to
continue.
5) The next screen will prompt you with a list to select the manufacturer and model
of your printer. From this menu, click Have Disk. Another menu will now pop up
for you to indicate the location of the print driver. With the LaserPro CD still in
your drive, click Browse and point to the file located at: D:\X252RX &
X380RX\LaserPro driver\WIN XP\Dv3.45\GL345.inf (where D is the driver letter
assigned to your CD-Rom drive) and click OPEN to have X252RX & X380RX
displayed as a valid printer.
6) Now select X252RX & X380RX from the list of printers (X252RX & X380RX
should be the only printer displayed on the list) and click Next to continue.
7) If a screen comes up informing you of the detection of a previous driver and asks
to keep the existing driver or use the new one, select Replace Existing Driver
and click Next to continue.
8) This screen will prompt you to provide a printer name. Simply type in <X252RX &
X380RX> and select Yes or No if you want to use this printer as the default
printer and click Next to continue.
NOTE
When working with the LaserPro X252RX & X380RX Print Driver within your graphics
software, you will need to have the X252RX & X380RX set as the default printer to get
proper output. If you select to not have the X252RX & X380RX be the default printer,
please remember to manually change this on your own from within the graphic software
printer selection area or from the Windows Control Panel
Printers and Faxes section.