GCC Technologies Jaguar J5-61, Руководство пользователя

Страница: 59 / 196

Jaguar V User Manual
The Control Panel 3-5
3.4 Menu Items
Below describes the functions of menu items
Menu or Key Function Setting Default
--- Media sizing ---
Roll To measure media width.
Maximum Media
Length 150 meters
Edge To measure media width and pull the media back till the front
paper sensor open.
Maximum Media
Length 150 meters
Single To measure media width and length.
Maximum Media
Length 10 meters
--- POWER ---
To indicate the power status.
[ Arrow Keys ]
1. To move the tool carriage position on X or Y axis.
2. To select functions or change values of settings.
[ ENTER ]
1. The displayed parameters will be saved automatically.
2. To set a new origin at the present tool carriage position.
In “offline” mode, moving the tool carriage to desired
position by [Arrow Keys], then press [ENTER] key to set a
new origin. While moving with the parameters of XY-axes
displayed, press [MISC] key will enable fine-tune
movement; press [MISC] key again to disable the function.
[ PAUSE/RESUME ]
To temporarily halt the cutting process.
To resume the process by press [Pause/Resume] key again.
[ ONLINE/OFFLINE ]
1. To switch between online mode and offline mode.
2. To stop the cutting job or abort the change of setting.
Once press this key, the cutting job will be terminated
immediately and cannot be resumed.
[ OFFSET ]
To set or modify the distance between the blade tip and the
center axis. 0.000~1.000mm 0.275mm
[ FORCE ]
To set or modify the value of tool force.
For Jaguar V_R, when the cutting force exceeds 450g, the
maximum cutting speed would be 15cm/sec and the cutting
quality would be Small Letter Mode (0.2g) and while the
cutting force is 300g-449g, the maximum cutting speed would
be 30 cm/sec and the cutting quality would be Fine Mode
(0.5g) 5~600gram;
5 gram/per step
80 gram
[ SPEED ]
Speed To set or modify tool speed at horizontal moving. 3~153cm/sec;
3cm/sec per step 72cm/sec
Up Speed To set or modify tool speed while the tool move from endpoint
to next start point at horizontal moving. 3~153cm/sec;
3cm/sec per step 72cm/sec
Quality To set or modify cutting quality.
While cutting small letter, set as “Small letter”.
While cutting in high speed, set as “Draft”.
For normal operation, set as “Normal”. Draft, Fair,
Normal, Fine,
Small Letter Normal