30
Part 2b - Creating a Desktop Printer
(via AppleTalk)
1.
Confirm that the Macintosh is properly
configured to communicate using
AppleTalk over Ethernet. Go to the Apple
menu, then to Control Panels and to
AppleTalk. In the AppleTalk window,
confirm that the “Connect via:” selection
is set to Ethernet. Close the control
panel. Click Save if prompted to save
settings.
2.
Make sure that all steps in the Hardware
Setup section of this manual have been
followed. Follow the Macintosh
installation steps in Part 1 of this section.
In Step 9, select “AppleTalk” as the
connection method and click “Setup
Printer.”
Due to potential incompatibilities between Apple’s Desktop Printer Utility and certain AppleTalk
networks, GCC does not recommend using the Apple Desktop Printer Utility to set up the Elite 21
Series printer over AppleTalk. As a result, the Elite 21 Series software uses the Chooser to set up the
printer over AppleTalk rather than the Desktop Printer Utility. Follow these steps to set up your
printer over an AppleTalk connection.
Содержание Elite 21DN+
Страница 1: ...GCC Elite 21 Series Getting Started Guide Elite 21N Elite 21DN...
Страница 8: ...6 Step 4 Remove Tape 1 Remove packaging tape from the front and rear covers of the printer...
Страница 11: ...9 6 Close the front cover Press on the center part of the front cover until the cover locks securely...
