BLT_PWM1 (Backlight Control Level)
JGPIO_SET1 (GPIO Default Setting)
CLRCMOS1 (Clear CMOS Header)
CLRCMOS1 allows you to clear the data in CMOS. To clear and reset the system parameters to default setup, please
turn off the computer and unplug the power cord from the power supply. After waiting for 15 seconds, use a jumper cap
to short pin2 and pin3 on CLRCMOS1 for 5 seconds. However, please do not clear the CMOS right after you update the
BIOS. If you need to clear the CMOS when you just finish updating the BIOS, you must boot up the system first, and
then shut it down before you do the clear-CMOS action. Please be noted that the password, date, time, user default
profile and MAC address will be cleared only if the CMOS battery is removed.
JGPIO_PWR1 (Digital Input / Output Power Select)
PWR_JP1 (ATX/AT Mode Selection)
SET_CM1 (COM1 Pin9 PWR Setting)
Setting
Description
1-2
+3.3V
2-3
+5V
Setting
Description
1-2
Pull-High
2-3
Pull-Low
Setting
Description
1-2
Default
2-3
Clear CMOS
Setting
Description
1-2
+12V
2-3
+5V
Setting
Description
1-2
AT Mode
2-3
ATX Mode
Setting
Description
1-2
+5V
2-3
+12V