GBC StreamWire, Руководство по обслуживанию

Страница: 59 / 455

GBC StreamWire 07/23/2020 RTPS
2-44
7. Manually move the Holder linear mechanism and watch if the sheet
metal feature blocks/unblocks S37 Holder Stack position sensor.
The sensor is blocked/unblocked properly
Yes - Go to Step 8;
No
- Escalate to second level
8. Do GP 6.5 to check M15 Holder linear drive motor
This clears the fault
Yes
- Return to normal operation;
No - Go to step 9
9. Inspect the springs for the Holder gates (PL 5.21).
Holder gates springs are present and not damaged
Yes - Go to Step 10;
No - Replace the missing/damaged spring
10. Do GP 6.3.5 FIRMWARE UPGRADE Procedure to Re-flash the
firmware for eWire.
This clears the fault
Yes - Return to normal operation;
No
- Go to Step 11
11. Do REP 11.2 “B” Main Control Board Replacement
.
This clears the fault
Yes
- Resume operation;
No - Escalate to second level
RTP 5.2 J371- S38 HOLDER POSITION ELEMENT TIMEOUT
J371 is triggered if it takes longer than specified time for the Holder to
reach S38 Holder at Element position sensor
1. Do GP 6.4 to check S38 Holder Element position sensor
This clears the fault
Yes - Return to normal operation;
No
- Go to Step 2
2. Check the Condition of the Holder linear drive belt- Front and Rear
(PL 5.21)
The timing belt is in good condition. There are no missing teeth
and the belt is not frayed
Yes - Go to Step 3;
No
- Replace the damaged timing belt (REP 8.11, 8.12) and resume
operation
3. Check the tension of the Holder linear drive belt tension- Front and
Rear (ADJ 1.6)
The tension of the timing belts is good
Yes - Go to Step 4;
No - Do to ADJ 1.6 to set the belt tension and resume operation
4. Visually check if the rollers of the Holder are centered in the cam
tracks.
The rollers are centered in the cam tracks
Yes - Go to Step 5;
No - Loosen the cam track assembly and bring the roller inside the
cam track. Resume operation