Page 6 - 10
© April 2001 General Binding Corporation
Applications
F 60 C Operation and Maintenance Manual
PROCESS CONTROL CHART
Materials - Mounting an image
Top material : N/A
Bottom material : N/A
Other material (s) : Image and a Pre-coated board
Motor Direction
Motor Speed
1
2
3
4
5
6
7
8
9
10
rang
e
Roller Pressure
RANGE
Notes: The image should not exceed the pre-coated board by more than 1 in. ( 2.5 cm ).
If the image is smaller than the pre-coated board, trim the board or pre-trim the release
liner around the image. Speed for mounting should be comfortable for the operator.
Use the footswitch for this application. Pressure will be dependent on the type of
substrate. Do not crush the substrate. Do not stop in the middle of the run. Refer to
helpful hints for mounting.
