Gazelle T4, Инструкции по сборке и использованию

Страница: 4 / 8

INSTALLING THE FLOOR
1. Remove all stakes and tie-downs.
2. If the rain fly is attached see REMOVING THE RAIN FLY.
3. If the gear loft is attached, partially remove them by unhooking two adjacent corners so that the roof hub can move freely.
4. From inside the tent, zip all the windows shut.
5. From inside the tent, gently pull the roof poles/hub down to collapse the roof. DO NOT stand directly underneath the hub
when collapsing.
6. From outside, zip the door shut to prevent tangling of poles. Push the center hub to collapse the wall. Do this to each wall.
7. Once all the hubs are collapsed, gather all corners of the of tent and fold together into a tight cone shape. Do not force the tent when
folding and watch for entanglement of poles.
NOTE: It helps to partially separate a small section of the hook/loop connection between the floor and the tent wall so that the air
trapped inside can escape, allowing for quicker and more condensed packing.
8. Take the provided strap and wrap it around the folded tent and secure for easier insertion into the duffle bag. Place the folded tent back
into the duffle bag with the hubs inserted into the closed end of the bag.
TAKE-DOWN INSTRUCTIONS
1. VERY IMPORTANT! Unhook the plastic hooks from each hub.
2. From inside the tent, gently pull the roof poles/hub down to collapse the roof. DO NOT stand directly underneath the hub when col-
lapsing.
3. One at a time, pull the rain fly poles straight out of the roof pole sockets.
4. Slide the rain fly off the tent.
5. Fold the rain fly and store in the duffle bag.
NOTE: Make sure the rain fly is clean and dry before folding and storing.
REMOVING THE RAIN FLY - MUST FOLLOW INSTRUCTIONS TO PREVENT POLE ENDS BENDING!
4. Enter the tent and push up to pop up the roof panels.
NOTE: This step should be done with caution as there is tension
on the roof hub and pole assemblies.
5. Outside the tent, fasten the plastic hooks to the eye bolt of the
respective wall panel. [ SEE FIGURE 9 ]
FIGURE 9
1. The tent must be set up before installing the floor.
2. The tent must be spread out, so it is taut and staked down.
3. Spread the floor out loosely inside the tent.
NOTE: Align the colored tabs at the center of each side of the
floor to the colored tabs at the center of the tent panels.
4. Start at the center of each wall using the colored aligning tabs as
guides. Press the hook and loop strips together, working towards
the corners. [ SEE FIGURE 10 ]
NOTE: The tent can be taken down and stored with or without
the floor installed.
FIGURE 10