Gauzy LC6 FLEX Controller, Инструкция по установке и эксплуатации

Страница: 12 / 28

12
Dry Contact Dimmer Control
1. Before proceeding make sure the main AC voltage is disconnected. Any
electrical connection should be done by a qualified electrician.
2. Connect AC mains to the LINE, NEUTRAL and GROUND terminals
respectively.
3. Connect terminals DT-ON/OFF & DO to COMMON through a dry contact
or a 3-way switch. The dry contact might be controlled from a computer
or a smart home system. Refer to the figure above.
4. Connect output terminals AC OUT 1, AC OUT 2 to the
film.
5. Connect the AC mains ON again.
During this step please make sure the switch is in the neutral position,
otherwise the unit can enter into a latched up state. If something like this
happens remove the AC mains, move the switch to the neutral position
and restore the power supply to the unit.
6. Toggling the switch to the UP position will dim the film to a
transparent state. When releasing the switch, the current transparent state
will be preserved.
7. To dim the film to translucent, toggle the switch to the DOWN state.
Dimmer
AC
OUT
FREQUENC
Y
ST
AT
US
CASCADE
DR
Y
CO
NT
AC
T
COMMON
N.C
OUT OK
ALARM
COMMON
OUT
COMMON
IN
MUTE
DO
COMMON
DT/ON-OFF
LINE
32 HZ
LINE/2
POWER IN
HV CNT
L
GR
OU
ND
N.C
NE
UT
RA
L
N.C
LIN
E
ON
-O
FF DT
DO
Dimmer
Wall Switch
Film Out
Line
Neutral
Ground
AC mains
110/220VAC
Film