GAUI NEX6, Руководство пользователя

Страница: 6 / 12

Section 4 - Rotorhead
Die Mitnehmerarme werden jeweils mit den passenden
Schraubenlängen lt. Explosionszeichnung ausgerüstet und mit den
Distanzscheiben 16 (W.3,1x4,6x0,6) versehen.
Apply some silicone grease to the shaft of ball end No. 18 and
screw it into the joint.
Srew the linkage Ball right into the Joint.
M3x20 screw with washer
W.3,1x4,6x0,6
M3x16 screw with wascher
W.3,1x4,6x0,6
Now attach the washout arms to the center hub.
Important:
First slide the center hub on the main shaft and secure the bolt No.
17 (M4x23) with a M4 lock nut.
Now tighten both screws M3x20 - see DETAIL D for reference
Complete the blades grips with the sleaves No. 21 and balde
screws. No. 22
Safety Check:
Check if the screws No. 6 (M4x8) are fully secured. In case you can
open these screws, just use thread locker und secure again.
DETAIL D
Attatch the Pitch Arms No. 3 to the Blade Grip
No. 1 using M2,6x6 screws and complete each wit
a pivot ball No. 13.
Important: Do not over tighten the the thr eads
of pivot ball No. 13.
Also use low torq for the M2,6 screws.
Washout arm attachment
Assemble the washout arms as showen in the explosion drawing.
Use the detailed illustratition on the left for refernce