GAUI NEX6, Руководство пользователя

Страница: 3 / 12

Section 1 - stacked frames upper section
Attatch all bearing blocks and shown parts on the right upper CF frame
Pay attenteion to the correct position and open side of Main Mast Bearing Block No. 2, see
DETAIL A1 und A2
DETAIL A2
DETAIL A1
The M3 x 14 set screw must be secured
carefully with threadlocker before attacth
the canopy mount No. 6
The illustration on the left shows the right CF
upper frame. This was fully equipped except for
the rear counter gear.
To ensure 100% alignment of the rotor shaft, it
should be inserted before tightening the screws
and remaining in the pedestals until all
surrounding screws are tightened.
Attatch the Servo Monunt No. 1and Canopy
Stand No. 6 on the outer side.
Preparation for installation of the counter
gear
The holes for the counter gear are to be
expanded approx. 0,3 mm towards the rear. Use
a 3mm round file, see DETAIL A3
DETAIL A1
Brake the edges of the 3mm holes carefully . This
enables a proper adjustment of the counter gear.