GAUI
G A UI
T AI SHIH HOBB Y CORPOR A TION
G A UI
T AI SHIH HOBB Y CORPOR A TION
P.13
Gear / Gain
A
初次飛行需校正四組ESC訊號的一制性(校正一次即可),否則會有低速啟動時,馬達有些轉有些不轉的現象.
打開發射機,先將微調置於中立.
將油門(THRO)桿撥至最大.(圖示為 Mode 1 遙控器)
將500X的電池接上.
此時你會聽到馬達發出登-登-登---登-登 5個音,接下來將油門撥桿朝下,此時你會聽到登-登---登 3個音
,此時將500X的電源關掉,便已完成指令校正.(其它設定值已出廠設定完成,詳細內容請參考電子變速器
設定說明.)
*若你聽到的聲音一開始是 登-登-登---登-登---登 6個音,那表示THRO的指令相反,請改變THRO的正反設定.
電子變速器校正
電子變速器校正
在執行電子變速器校正前應先把GU-344的陀螺儀關掉，你可以
先將控制陀螺感度的綠色訊號線移除，並將感度旋扭A轉到最小
(逆時鐘方向)，等校正後再接回復原。
Adjust and unify the starting signal for each ESC before first flight to make sure each motor is
run by its ESC with the same output signal. Otherwise under low speed start-up, some motors
will turn, some will not."
1. Switch on transmitter power,
set all trims to neutral.
2. Move the throttle stick to the top position
(figure indicates the “THOR” control stick for
“MODE 1” transmitter )
3.Connect the battery to the 500X.
4.After battery is connected to the 500X, the motor will come up with 5 corresponding tones
(♪-♪-♪---♪-♪), move the throttle stick to the lowest position, the motor will comeup with 3
acknowledge tones(♪-♪---♪), simply disconnect the battery from the 500X, setting is
completed (The ESCs are initialized with Factory Default setting for 500X, referring to page
17 for detailed information on ESC setting.)* If the motor come up with 6 corresponding tones
after the battery is connected, it means your "Throttle command” is set to reverse, change
your "Throttle command" to Normal on your transmitter and re-start "Step 2 to 4” above.
MODE 1
ESC tuning
ESC tuning
GU-344 stabilizer should be turned off while calibrating the four ESCs
(*Remove Green Cable connection to Receiver, Turn Trim A to 4:30
o'clock position (Minimum GAIN), return to original conditions after
ESCs calibration are done!
