Gator GRV127KT, Руководство пользователя

Страница: 5 / 12

5
Installing the camera
In most instances, the camera is best mounted above the
vehicles license plate as shown here.
1. Connect the RED wire of the Cameras Power Harness to the
wire that supplies power to the reversing light globe (the wire that
is energized only when the car is put into reverse). Before
making the electrical connection, temporarily disconnect the
camera from the power plug whilst making the connection to the
reversing light globe. Use a suitable splicing/crimp connector
(scotch lock type) or strip connector. This connection can also be
soldered, making sure to insulate the joint with electrical
insulation when done. The camera has only one wire to connect
(positive (+). There is no need to hook up a ground earth wire as
the camera gets its earth through the RCA cable. Hooking up the
ground earth may cause a ground loop. In this case horizontal
lines will appear in the image.
NOTE: CAN BUS
In the event that the cars reversing lights are driven by CAN BUS
the above wiring system may not trigger the system correctly. It
may even create a globe fault warning. In this case a CAN BUS
Hole for cable