GA600AC Sliding Gate Opener User Manual
19
Insert the wire into the number on
the terminal that you are looking to
connect to. Refer to Page 19.
Tighten with a screwdriver
to secure the wire in place.
Note: If require to change the moving direction, the wires of 11 and 13 on J5 Terminal
have to be swapped with each other.
Wiring to the Terminal
J6 Terminal:
Port 13 and Port 14 output door closing in place
feedback signals.
J5Terminal:
Limit Switch and Accessories
Additional accessories sold separately
Port 12
：
Open Limit Switch
Port 11
：
Limit Switch Common Port
Port 10
：
Close Limit Switch
Port 9
：
Ground/Earth (GND)
Port 8
：
Photocell input (N.C.).
If no photocell is fitted, use a
jumper between Ports 8 & 9.
Port 7
：
Power supply for accessories (+15V)
J4 Terminal: (as per Figure 18)
Port 6:
External Push Button Pedestrian Switch.
Port 5:
External button Single cycle button. (Cycle open/stop/close)
Port 4
：
Common Port for All External Control Push Button
Port 3
：
External Stop Push Button Switch.
Port 2
：
External Open Push Button Switch.
Port 1
：
External Close Push Button Switch.
Using a screwdriver to
loosen the screw on the
side of the terminal.
1
2
3
4
5
6
7
8
9
10
11
12
13
14
J6
J5
J4
