124756 / 6-2014
34
T R O U B L E S H O O T I N G
Troubleshooting Chart
PROBLEM
CAUSE
CORRECTION
Leaving center valley.
Rear gangs cutting too deep.
Level disk using threaded adjustment bolts above
each cylinder/wheel assembly.
Gangs plugging.
Extremely wet field conditions.
Allow to dry if possible.
Adjust machine to run rear gangs deeper.
Poor penetration, center
section.
Disk not running level from front
to rear.
Level disk using threaded adjustment bolts above
each cylinder/wheel assembly.
Wheels are holding disk out of the
ground.
Retract hydraulic cylinders for desired depth.
Hydraulic cylinders not
synchronized.
Hydraulics have drifted or air has
entered the system.
Hold hydraulic control lever with the hydraulic
cylinders fully extended 15 seconds to synchronize
rephasing cylinders.
Leaving ridge 2-4 feet from
disk center.
Side drift.
Level disk using threaded adjustment bolts above
each cylinder/wheel assembly.
Recheck gang spacing.
Plugging at disk front center.
Wet conditions or extremely high
residue conditions.
Level disk using threaded adjustment bolts above
each cylinder/wheel assembly.
Wings do not penetrate.
Dry/hard conditions.
Adjust wing cylinders to lift wheels off ground.
Содержание Magnum Coulter Disk
