Gater WYZ34FS600V, Руководство оператора

Страница: 7 / 20

7
BEFORE OPERATING
Fill engine crankcase as per engine manufacturer’s
manual.
ENGINE DOES NOT HAVE OIL IN
CRANKCASE FROM THE FACTORY. Add proper
fuel to fuel tank, open shut-off valve. The battery is
a gel-cell and will not require acid. Before hooking
up the ground wires, make sure that the engine has
been filled to the proper level with oil. If battery will
not turn the engine over after hooking the wires up
it may require a charge for 15 to 20 minutes.
ASSEMBLY INSTRUCTIONS
1.
Remove unit from the crate.
2.
Remove seat from packing. Remove the 5/16 x
3/4 bolts and disc spring washers from the seat
plate. Attach seat to the seat plate using these
same bolts and tighten.
3. Plug in the seat switch.
4. Connect the ground wire to the battery using
the bolt on the negative battery post.
5. Remove the 5/16 x 1-1/4 bolts from the top side
of the handle mounts. Rotate the handle to
match up the holes, re-install the bolts and
tighten.
6.
Put oil in engine. See the engine Manual for
type and quantity required.
7. Put fuel in fuel tank.
8.
Check all tire pressures.
9.
Read “Operator’s Manual” before starting unit.
STARTING ENGINE
The throttle c control, ignition switch and choke
control are located between the motion control
levers on the front panel under the front of the seat.
Because of a built-in safety interlock system, your
machine will not start unless the seat is occupied.
TO START ENGINE :
1. occupy seat,
2. set park brake,
3. leave the motion control levers swung out,
4. move throttle control lever all the way to choke
position.
5. Turn ignition key to start position to engage
starter
6. Release the key when engine starts.
Ignition switch is spring loaded and will return to run
position automatically.
Slowly return choke to run position once the engine
has started.
STOPPING ENGINE
TO STOP ENGINE:
Move throttle lever to idle position and turn ignition
key to
“off” position. If engine has been working
hard or is hot, allow engine to idle for a short period
of time before turning off key. This practice will
help cool engine before stopping.
IN CASE OF EMERGENTY engine may be
stopped by turning ignition key to “OFF” position.