PAGE 5
G427
INSTRUCTION MANUAL
INSTALLATION
Installing the camera
In most instances, the camera is best mounted above the vehicles license plate as shown here.
Where this is not possible there are other camera combinations that will suit your individual
application. When mounting the camera, make sure that the camera does not cover any part of the
license plate. Choose a position that does not impede the access/operation of the boot release or
tailgate latch.
To install the reverse camera, take the following steps:
1.Remove the rear license plate from the vehicle by undoing the bolts/screws.
2.Remove the wax paper from the adhesive strip on the back of the camera mounting bracket to
expose the adhesive surface. Carefully align the brackets arm so that the top edge of the arms align
to the top edge of where the license plate would sit and stick it in place making sure that 2 holes in
the mounting bracket align with the mounting holes of the license plate.
3.With the license plate off, check if there are pre-existing holes through which the cables from the
camera can be passed through to the boot of the vehicle as in Fig. 2.If there are no pre-existing
holes carefully drill a hole of sufficient diameter to allow the cables to be passed into the interior of
the vehicle (through a rubber grommet) and seal the hole with silicone to avoid water leakage.
4.Refit the license plate over the camera bracket using the original bolts/screws.
