Copyright Gatekeeper Systems 2011
Page 6 of 9
Rev 2.0
Use the supplied grommet so that the metal of the bus does not cut into the camera cable when
it is routed through the exterior of the bus.
The SP210 should be aimed so that the resulting image appears as in Figure 5 when the
vehicle is located 22 back and 6 feet away from the bus.
This aiming should be considered preliminary aiming only. It is strongly recommended that final
aiming be done with drive bys when the bus is located on a typical road that it will run on – see
section – Final Aiming
The SP-210 has 2 knobs at the bottom to zoom and focus the camera.
Loosen the two protruding screws on the SP-210, one screw adjusts the zoom level and the
other adjusts the focus. Note: these two adjustments interact with each other so the focus must
to be reset when zoom level is changed. When the correct zoom and focus is achieved, tighten
the screws. Be sure to not over tighten them.
Cable passes through this slot
Fasten supplied Tek screws in the curved slots
Cable passes through this slot
Fasten supplied Tek screws in the curved slots
Cable passes through this slot
Fasten supplied Tek screws in the curved slots
