19
20
•
Guidelines of employers‘ liability insurance associations
•
Trade regulations
•
If the InductWarm
®
130 appliance is being installed in close proximity to a wall, partition walls, kitchen furniture,
decorative panelling, etc., it is recommended that these objects consist of non-combustible material; otherwise
they must be covered with a suitable non-combustible, heat-insulating material and the fire safety regulations
are to be observed extremely carefully.
Intended use
•
If the glass ceramic shell is broken or even slightly cracked, then the InductWarm
®
130 appliance must be swit-
ched off and disconnected from the electrical supply. Do not touch any parts inside the appliance.
•
The surface of the InductWarm
®
130 appliance should not be used for storage.
•
Only use suitable pans with a minimum base diameter of 12 cm for induction warming. Theoretically, it is possible
to use smaller dishes, but this may result in the following:
– Reduced efficiency
– Pan recognition may not be possible
– Radiation may be greater
•
Never heat a pan while empty. This could cause the pan to overheat.
•
Once you have removed the pan after warming, remember to switch the InductWarm
®
130 appliance off, unless
you intend to use it again straight away. This will prevent the appliance from heating up accidentally should you
or someone else place a pan on the warming surface.
•
Do not heat up tins or other sealed containers, as these can explode! Items that are unsuitable for use include any
dishes that are not specifically intended for induction appliances, as well as metal splash guards, aluminium foil,
cutlery, jewellery, watches, metallic objects, etc.
•
The induction hob is officially switched on as soon as the rotary switch is moved away from the off position (red
line aligned with status indicator). Whenever the hob is not in use, the appliance must be switched off.
•
Symbol explanation:
This exclamation mark shows warnings.
This radiation warns of non-ionising electromagnetic radiation.
Risks
The InductWarm
®
130 appliance may represent a source of danger if the information in these operating instructions
is not heeded, setup, maintenance or repair work is undertaken by non-authorised persons, or the InductWarm
®
130
appliance is used incorrectly or for purposes other than its intended use. Other risk may be:
•
Risk of destruction
When the induction surface is not only being used for warming, it is necessary to ensure that the devices are
turned off. Otherwise damage or burnings may occur.
•
Electrical shock
Do not expose this system to liquids or metal objects which may cause an electric shock.
•
Environmental conditions
The system must be mounted in a clean, dry indoor place and the relative humidity must not exceed 60%. To avoid
overheating, ensure good ventilation. The environmental temperature must not exceed 40°C.
•
Risk of burns
The used dishes are hot during operation and can cause burns. For touching the hot parts please use potholders
or gloves.
Because o
f the reflection heat of the dishes there is a high temperature above the induction area. Therefore a
cooling time of five minutes must be followed.
Do not put any melting materials on the heated surface.
It should be noted that necklaces and rings may heat up next to the induction field and cause burnings.
Because of the high temperatures which may occur and which can destroy the dish, there is a risk of burning,
when the dishes are running empty on the induction device.
Do not use any metal spoons in combination with the InductWarm
®
130 device.
Before the InductWarm
®
130 please remove the caution sticker from the device. Otherwise it can cause fire.
General Information
Liability
The manufacturer‘s warranty covers all defects in design, production and materials. All other claims are excluded.
All data and notes in this instruction are prepared with consideration to the statutory standards and regulations. The
manufacturer will not be liable for:
➢
•
Failure to observe the instructions
•
Damages caused by inappropriate handling
•
Deployment of unqualified staff
•
Unauthorized modification
•
Technical modifications ➢
•
Use of uncertified spare parts
Please note:
Do not use the InductWarm
®
130 appliance if you notice damage or malfunctions.
If you wear a pacemaker, check with your doctor whether you are allowed near an induction cooking
appliance.
Repairs
Repairs may only be carried out by authorised service personnel. Contact your dealer, a trained Gastros Switzerland
AG Service Partner or our customer service department. You can contact our customer service department at:
[email protected]
Warming with Induction
The induction coil (1) beneath the glass ceramic dish generates an alternating electromagnetic field (2) that produces
heat in the base of an induction dish item (3) through the principle of eddy currents. The automatic dish recognition
only switches on the generator when a pan is placed on the appliance.