5.
Operation
5.1. Customer parameters
Certain parameters can be changed by the customer.
5.1.1.
Call up the parameter menu
If the machine is in the OFF state, you can switch to the parameter menu by pressing the key or
for 10
seconds.
5.1.2.
Change parameter pages
The various parameter pages can be called up with the key
.
5.1.3.
Change parameters
The parameters can be changed with the keys and
.
5.1.4.
Exit the parameter menu and save the new values
To exit the parameter menu, press the key
.
The changed values are saved and are retained even in the event of a power failure.
5.1.5.
Example of the parameter menu
Figure 3: Parameter menu
5.1.6.
Modi
fi
able parameters
•
Sound-Level:
The volume of the buzzer can be changed between 0 (o
ff
) and 10 (very loud).
•
Standby- time:
The standby time for the TW can be set between 5 and 120 minutes. If the "-" button is pressed for 5 min-
utes, the standby mode is switched o
ff
(O
ff
)
•
Standby- temperature:
The standby temperature of the TW can be changed between 30 and 80 ° C.
•
Monitoring drying cycle:
After switching on, the temperature must not rise more than the set temperature di
ff
erence (10-80 ° C) for
the
fi
rst 60 seconds. If the temperature rises more, an error message is output (too little water / oil) and
the control goes into the o
ff
state.
•
Temperature limit for the clean function:
If the temperature is higher than this set temperature, the clean function is blocked.
11_Operation manual Pastacooker Gastro 8 V1_3_e
Page of
Rorschach, 19.03.2018
7
19
