Gastrofrit 110135, Руководство по эксплуатации, Страница: 6 / 24

6
www.gastrofrit.ch
© Switzerland Gastrofrit AG
Pastacooker error catalog
Error description / display How to fix Remarks
1 Error 1
Call up the PT 100 menu
Note the display
Check PT-1000 connection
If, ok, then measure the PT-1000
ohmic value
OK = about 108 ohms / 20 ° C
NOK = 0 ohms or infinite
2 Machine heats up through unregulated Check contactor
Check software version
Perform a CPU reset
Reset limiter button
Contactor sticks, contactor has to
be checked and possibly replaced
3 conventional machine heats through
unregulated
Check thermostat
check contactor
Thermostat misadjusted and not
adjusted
4 The machine only heats when the red
heating pulse switch is pressed
Replace heating limit switch Can`t always be replaced
must be bridged
5 No indication on the display De-energize the device
Electronics defective
Change control
6 Residual current switch / fuse blows out The heater has a short circuit
Check wiring
burnt heater plug
Phase – Phase oder Phase-
0-wire short circuit
SSR/ Triac has short circuit
7 Conventional machine, power switch
green does not ligh up
Press the limiter button or
replace.
8 Lift motors only run halfway up/down Replace capacitor 33μF/ 270V
clean the lift motor
9 Lift motors are moving in the wrong
direction
Capacitors 33μF/ 270V
double mounted.
Check cable connection of hoist
motor (phases reversed)
Capacitor value cancels
corresponds to the value if no
capacitor is installed
10 No water supply Check solenoid valve Solenoid valve cold water up to
50ºC
Solenoid valve hot water up to
100ºC
11 Machine leaking Check PT-1000 seal
Check drain system
Check water supply