Gastrodomus S2F70G, Инструкция по эксплуатации

Страница: 13 / 16

13
3.2 The connection of the gas:
3.3 Note:
4. usage:
3.4 maintenance:
- before installation the equipment, must install a quick cut off gas valve, within reach, near and
above the equipment.
- must make sure that the gas used is the same gas required by the equipment. Otherwise, please
do not connect the equipment with the gas, the gas pipe should be painted in yellow.
- the gas pipe connected with the equipment should be made in proper metal.
- the equipment should be tested with LPG first.
- if the gas pressure from the pipe is 10% different from the required pressure, the gas regulating
valve shall be necessary, in order to meet the rated pressure.
- after connection with the gas pipe, use the soap-suds or the instruments to check the leakage of
jointing parts, NEVER and MUST NOT use the open fire to check the leakage.
- must never put flammable things such as towel on the top of the equipment, otherwise, there is
the risk of fire;
- after using the equipment, must switch off the gas immediately;
- if there is any leakage of gas, must switch off the gas immediately, open the windows to
strengthen the ventilation, must never touch the switch of electricity power. Must ensure the
equipment recovers in good working condition, then start using the equipment.
4.1 the above stove
- Turn the knob from “●” to “
*
” anticlockwise, push the knob for 20 seconds, in order to ignite the
small burner by igniters; if failed in ignition of the small burner, please repeat the above procedure;
- Clean the burners or the slag tray at fixed period;
- If the equipment will not be used for a long time, wet the cloth with gasoline, clean the surface of
the equipment, then put the equipment in the well ventilated place;
- Clean the surface of stainless steel top by warm soap water everyday, then clean it completely
with water. No direct flushing is allowed;
- When cleaning, no detergent containing abradant, steel brush or knives are allowed. Because
the residue of steel will rust. Please wipe the surface in accordance with the polishing direction
of the material, no detergent with chlorine(such as bleach, hydrochloric acid, etc) are allowed to
clean the surface of the stainless steel, even the solution is diluted;
- Must not use caustic substance (such as KCL) to clean the floor under the equipment;
- Please clean the burners or the dirt on the block board usually(it is better once a week);
- Must not change the ventilation space of the equipment;
- 90% of total weight is metal(stainless steel, steel, aluminium, galvanized steel) please deal with
the discarded equipment according to environment protecting laws of importing countries
- Must not use the wrong gas and the high & middle pressure regulator for the equipment. The
equipment only applies to low pressure regulator.