21
The
appliance
turns on,
but the
temperature
is too high/
low
Too much ice on the evaporator
Stop the machine and defrost
manually
Condenser blocked with dust
Call your agent or qualified
technician
Appliance is located near a heat source
or air flow to the condenser is being
interrupted
Move the refrigerator to a more
suitable location
Ambient temperature is too high
Increase ventilation or move
appliance to a cooler position
Unsuitable foodstuffs are being stored in
the appliance
Remove any excessive hot
foodstuffs or blockages to the
fan
Appliance is overloaded
Reduce the amount of food
stored in the appliance
The
appliance is
unusually
loud
Loose nut/screw
Check and tighten all nuts and
screws
The appliance has not been installed in
a level or stable position
Check installation position and
change if necessary
The
appliance
has difficulty
in reaching
and/or
maintaining
the set
temperature
The set temperature is too low.
Check that the parameters set
correspond to your temperature
requirements.
Temperature probes broken or faulty.
Check the integrity of the
temperature probe or replace the
probe
There are refrigerant gas or fluid leaks
Identify the leak and close t (get a
specialist technician to perform
the check and repair).
The condenser fins are covered with
dust.
Carefully remove dirt with a soft
bristle brush
Loss of cooling power caused by
frequent and/or prolonged opening of
the door.
check that the system works
properly.Check that there are no
obstructions in the air vents.
The door gasket is not well sealed with
condensed water
Remove dust from the gasket with
a hair dryer or use hot water at 45
° C
