16
17
insert and the glass insert lid set (lid ring with large opening and large lid). Especially
delicate food that could burn easily when heated on a range, can be cooked this
way without burning. Thus the appliance is perfectly suited for heating delicate food
(e.g. baby food) and melting chocolate or butter, or cooking food that is vigorously
frothing when cooked on a range.
The appliance provides a completely programmable cooking program (“Custom”)
for preparing food in the glass insert. If you start this program with new values set,
the new values will be kept in memory—even after shut off and disconnecting the
appliance from the power supply.
The following cooking programs are offered
Cooking Program
Temperature Time
Keep Warm
Hot water
100°C
After reaching the set temperature,
the appliance will switch off immediately.
no
Boil
100°C
Adjustable from 30 seconds (0m30s) to
30 minutes (0h30m).
60 minutes
Yoghurt
45°C
Adjustable from 8 hours (8h00m) to 12
hours (12h00m).
no
Baby
55°C
- First beep after 2:30 minutes (2m30s);
- further beeps every 40 seconds.
no
Custom (completely
programmable)
40°C - 100°C
Adjustable from 0:00 minutes (0h00m) to
12:00 hours (12h00m).
60 minutes
For using the glass insert, the kettle must be filled with 0.5 litres (500 ml / MIN) to
1.1 litres (maximum) of water. You should adjust the amount of water within the
kettle according to the amount of food in the glass insert. Otherwise, the glass insert
could swim within the kettle and the lid can not be closed properly. Up to 0.48 litres
(480 ml) of food or beverages may be filled into the glass insert. For heating, hang
the glass insert into the kettle via the glass insert lid ring. This way, your food will
not burn during cooking. The water within the kettle can be heated from 40°C to
100°C (boiling temperature). Using the program “Custom”, you can set temperature
and cooking time as you like.
Important:
The large glass insert lid ring will only lay loosely on the kettle to ensu-
re that you can lift the glass insert easily out of the kettle by the lid ring. Thus, you
may not tilt the kettle with the glass insert hanging in the kettle.
The “Baby” program is pre-defined for warming up 150 ml to 170 ml milk or baby
food (approx. 190 g mash) to 35-40°C in approx. 5-6 minutes. If you wish to heat
up larger amounts, simply leave the glass insert holding the food in the kettle some-
what longer.
SELF-RESETTING DRY BOIL PROTECTION
The water kettle is fitted with a self-resetting dry boil protection device, which safegu-
ards against overheating of the heating elements. Overheating may be caused by …
• too much scale on the heating elements. De-scale the kettle in time (see: ‘Care
and Cleaning’).
• too little water in the kettle. Always observe the MIN filling level (0.5 litre).
Please keep in mind, that water will vaporize, when left for a long time in the
kettle on high temperature. Observe the filling level during operation.
If overheating occurs, the kettle will automatically switch off the heating elements. In
this case, remove the kettle from the base and pour out the water. Then leave the
kettle cool down by waiting at least 30 minutes. Thereafter, you can reactivate the
appliance.
BEFORE FIRST USE
WARNING:
DO NOT let young children play with the appliance or any
part of it! The glass parts (kettle, glass insert, glass lid) are fragile. Always use
special care when handling the glass parts. Even small splinters and shards
could cause severe injuries, when getting into your food or beverages. Thus,
do not use glass parts again, when there are any cracks or chipped edges. Do
not pour cold water into the hot kettle. Always leave the kettle cool down
before filling it again.
For operation, always unwind the power cord completely
to avoid hazard due to overheating, fire, and electric shock. Always unplug the
appliance before cleaning it, and when it is not in use.
Do not place the kettle or
power base in an automatic dishwasher.
Do not place or immerse the appliance
(power base and kettle) or power cord in water or other liquids or spill any liquids
on the power base, power cord, or the exterior of the kettle. For filling, always
remove the kettle from the power base. Do not use any abrasive or corrosive clea-
ners for cleaning to avoid damage to the surfaces.
1. Unpack the appliance and all parts and accessories carefully. Check that no
parts are damaged or missing (see: ‘Knowing Your New Design Tea & More
Advanced’). Carefully remove all packaging, shipping materials, stickers, and
promotional materials. However, DO NOT remove the model label.
2. Before first use and after a longer period of storage, clean all parts of the appli-
