51
6.
Close the opening of the lid with the inner lid (1). The inner lid
has two small guide pins that fit into the corresponding holes on the
refill opening of the lid. Turn the inner lid after insertion clockwise.
The inner lid positioned securely after latching with a ›click‹ and no
longer can be raised (pic. 2).
attENtioN:
The blades of the knifes are very sharp. Pay attention
handling it and if possible only hold on to the socket.
imPoRtaNt:
Do not tighten the blade assembly housing with force
or too tight to avoid damaging the appliance or the sealing ring.
attENtioN:
Ensure the blender jug is leak-proof and that the blade
assembly housing and the sealing ring are in proper position and
firmly locked before putting the blender jug on the motorblock. Without the blade assembly
housing the bottom of the blender jug is open. Spilled liquids might run right into the motor.
Always wipe off spilled liquids immediately. Never let any liquids run into the motorblock or
underneath it to avoid electric shock. When liquids are spilled on the motor housing, immedi-
ately unplug the appliance and dry the motor housing to avoid risk of electric shock or fire.
Do not
attempt to operate the appliance, when liquids are on or in the motor housing.
attENtioN:
Never place only the socket or the knife unit on the motorblock. Never touch
the drive gear when the plug is connected to the power outlet.
attENtioN:
Take care always to ensure that no liquids run into the motor base or onto the
motor base. If liquid has run over the housing of the motor base, turn off the power immedi-
ately and unplug the power cord from the outlet. Wipe the liquid then with a dry cloth, then
dry the housing well.
waRNiNg:
If liquid has been spilled into the inside of the motor base, do not connect the
appliance to the power outlet in order to avoid the risk of electric shock or fire, and damage
to the equipment. Have the appliance checked in this case in a specialised service centre.
attENtioN:
Never try to sharpen the blade. Replace the blade if it is blunt. Please contact
our service department for the replacement part.
Pic. 2
Single parts of the blender jug
Blender jug assembled
